ACID #8 can be applied to the following surfaces:
Bare steel
Aluminum
Galvanized and Zinc coated steels
Fully cured paint
Polyester bodyfillers and F.R.P.
Thoroughly clean and degrease surfaces with a suitable spirit wipe or thinner. Abrade wet or dry with 280 –320 abrasive. Re-clean,dry and degrease.
Shake aerosol thoroughly before use for a minimum of 2 minutes.
Keep the can 12 ins. from the panel,spray light even coats
Apply 1-2 coats.
Allow 3-5 minutes flash off time between coats.
Allow 10-20 minutes before overcoating.
Drying time is dependent upon film thickness, humidity and temperature.
Over-painting Under normal circumstances it is not necessary to flat ACID #8 and should be directly overcoated.
ACID #8 may be overcoated directly with top coat.
However, if the repair requires additional build a primer filler should be used before top coat is applied.
