Pro-Tex Truck Bed Liner Kit (Black)
PRO-TEX is a urethane-based truckbed liner system that provides a hard, durable finish with superior protection. The coating demonstrates great adhesion, film build and flexibility. PRO-TEX is versatile and bonds permanently to most properly prepared surfaces, including steel, aluminum, concrete, wood and fiberglass. In addition, the unique formulation is resistant to most chemicals. 40640 Kit Contains – one gal. PRO-TEX, two qts. 40674 CATALYST, two plastic Schutz bottles and two paint pals. Easy to use- no special equipment needed Outstanding adhesion and chemical resistance Will not fade Bonds to most surfaces Flexible Sound dampening Air and water tight No maintenance Handling and Application PREPARATION: Existing OEM Paint Pressure wash the surface. Next, clean with 38373 SEM SOLVE. Then, sand the surface with 180-220 grit paper. If rust is present, grind or sandblast until all rust is removed. Apply a 2K epoxy primer, such as ML01( ) METALOCK DTM HIGH BUILD PRIMER or a urethane primer over any bare metal, following the manufacturer’s instructions. Sand the primer with 180-220 grit paper. Blow off dust and tack clean. Fiberglass and SMC Prime the surface with a 2K epoxy primer, such as ML01( ) METALOCK DTM HIGH BUILD PRIMER or a urethane primer following the manufacturer’s instructions. Sand the primer with 180-220 grit paper, blow off dust and tack clean. Wood Pressure wash surface first and allow to fully dry. Sand the surface with 180-220 grit paper, blow off the dust and tack clean. Concrete Pressure wash surface and allow to fully dry. MIXING : NOTE: Do not catalyze more than 1 quart of PRO-TEX at a time due to the short working time. Use 71001 PRO-TEX TRUCKBED LINER GUN or a premium undercoating gun with a ½” pick-up tube at 45-90 psi. Do not use a standard Schutz type applicator gun as the diameter of the pick-up tube is not large enough to deliver PRO-TEX effectively. Pot Life @ 70°F (21°C) and 50% R.H. 20 minutes Coverage 120-125 ft² per gallon @ 10 mils DFT Recommended Coats 2-3 coats Optimum Film Thickness 15-20 mils Dust Free Time 60-90 minutes Heat Cure Recommendations 45 minute flash, 1 hour at 120ºF (49°C) Delivery Time 8 hours (air dry), allow 48 hours before use of truckbed
|
