Kleen-Strip - Bulldog® Sealer & Adhesion Promoter : QBDS12327

Shake well and filter before each use to secure uniform mixture.

Sealer over Primed or Painted Metal Surfaces:

1. Sand all areas to be painted.

2. Clean area thoroughly with Prep-All Wax & Grease Remover,

wiping off as you go with a clean, dry rag.

3. Blow and tack surface.

4. Spray 1-2 even mist coats of Bulldog, allowing to flash 5 minutes

between coats.

5. Bulldog dries to a tack free clear finish in 5 minutes. Dry times may

vary based on temperature and humidity.

6. Apply basecoat and clearcoat according to manufacturer’s instructions.

Adhesion Promoter for Plastic Parts:

1. Clean area with Bulldog Abrasive Cleaner, using a gray or green scuff pad.

2. Rinse thoroughly with plenty of water. Wipe dry using a clean cloth

and an air hose.

3. Sprinkle an area with water. If water sheets, you are ready to proceed with

Bulldog application. If water beads, the cleaning steps 1-3 must be repeated.

4. Spray 1-2 even mist coats of Bulldog, allowing to flash 5 minutes between coats.

5. Bulldog dries to a tack free clear finish in 5 minutes. Dry times may vary based

on temperature and humidity.

6. Apply basecoat and clearcoat according to manufacturer’s instructions.

Drying Times:

temperature and humidity.

with no issue. If the part is left longer than 24 hours it needs to be scuffed and tacked, again. Apply 1 light

coat of Bulldog before applying basecoat.

be taken to keep lacquer thinner away from freshly finished surfaces. Clean spray gun according to

manufacturer’s instructions.