PREPARATION: Use masking paper and tape to mask seams and trim openings. This will prevent remover from entering and subsequently causing bleed-back stripping of new finish.
DIRECTIONS: Carefully read all cautions and instructions before use. Protect hands with solvent-resistant gloves and eyes with safety glasses. Shake well.
APPLICATION: Spray on painted surface holding can in an upright position, pointing arrow on top of button away from you, at a distance of approximately 8” to 12” from surface. In order to avoid sagging on vertical surfaces, use a back and forth motion to apply a generous, but even coat. Allow remover to work until finish is blistered or softened completely. Many finishes will blister or soften in 10 -15 minutes, but others may require 10 - 30 minutes or longer. Some epoxies and primers may require more than one application. If a repeat application of this remover is required, insure that the surface is thoroughly dry before proceeding.
REMOVAL: When remover action is completed, remove paint with a flexible plastic scraper. Once the blistered paint has been removed, the surface must be washed off with either a solvent or water to flush off any residue. Allow surface to dry before applying new finish. Prime metal as soon as possible to prevent flash rust from occurring.
NOTE: For best results, apply at temperatures of 70°F to 90°F and avoid direct sunlight or strong breezes. Not recommended for use on fiberglass. Do not apply on plastics or any other synthetic surfaces. Before using on surfaces other than metal, first test suitability. User accepts all responsibility for such use.
