Surf City Garage Interior and Exterior Car Detailing Meguiars Car Wax & Detailing Products Auto-Air Colors Water-Based Paint Wizards Car Wash and Shine Flitz Metal Polish & Detailing Wax Sprayway Glass Cleaner and Shine Products California Car Duster California Water Blade
ShineGear.com offers a 100% secure shopping & checkout experience.
Weld-Thru Coating II (12.75oz) Aerosol coating designed to be applied to metal surfaces prior to welding to provide corrosion protection after welding. Dries fast with minimum spatter. Meets MIR requirements. Directions for use: 1. Remove all paint, rust, oil, and grease from the area to be coated. Surface must be bare metal that is clean and dry. 2. Shake can of 3M™ Weld-Thru II for one minute after agitator is heard. Shake frequently during use. 3. Hold can 10-12 inches from surface to be coated. Press actuator tip firmly and use steady and even strokes when spraying. 4. Apply two light coats (1 mil dry thickness) on both mating surfaces. Allow solvents to flash between coats. Coating must be dry to the touch (normally 5-10 minutes at room temperature) before parts can be MIG welded. If using a resistance spot welder, allow 15-20 minutes of dry time before welding. 5. Invert can and spray to purge nozzle.
Aerosol coating designed to be applied to metal surfaces prior to welding to provide corrosion protection after welding. Dries fast with minimum spatter. Meets MIR requirements.
Directions for use:
1. Remove all paint, rust, oil, and grease from the area to be coated. Surface must be bare metal that is clean and dry.
2. Shake can of 3M™ Weld-Thru II for one minute after agitator is heard. Shake frequently during use.
3. Hold can 10-12 inches from surface to be coated. Press actuator tip firmly and use steady and even strokes when spraying.
4. Apply two light coats (1 mil dry thickness) on both mating surfaces. Allow solvents to flash between coats. Coating must be dry to the touch (normally 5-10 minutes at room temperature) before parts can be MIG welded. If using a resistance spot welder, allow 15-20 minutes of dry time before welding.
5. Invert can and spray to
6. Grind weld with a 3M™ GREEN CORPS™ fibre disc, being sure to remove any exposed 3M™ Weld-Thru II prior to applying plastic filler or other top coat.
General Corrosion Protection:
In non-cosmetic areas where plastic filler is not to be used, you may apply 3-4 coats of 3M™ Weld-Thru II to the weld areas after grinding. When dry, top coat the weld area with 3M™ Rust Fighter-I (PN 08892), a 3M™ Undercoating product, or primer and paint.
Weld-Thru Coating II (12.75oz)
Weld-Thru Coating II (12.75oz) Product Reviews : Write a review
My Account Contact Us Return Policy Privacy Terms
Website Copyright ShineGear.com 2008-2011 Ecommerce Websites by OuterBox Solutions
Link to Us! Shine Gear Auto Detailing Sitemap Resources
